Ceramic Heater 314

E1 - Temperature sensor open circuit: Unplug it from the power source and contact Customer Support.
E2 - Temperature sensor short circuit: Unplug it from the power source and contact Customer Support.
FF - Overheat Protection: Unplug and wait for it to cool down before plugging in again.
P4 - Tip-Over Protection: Place the heater back on a flat, level and stable surface.

1. Make sure the power cord is properly connected to a powered electrical outlet.
2. If overheat protection has been activated, unplug the heater and allow it to cool, then remove any objects on or near the heater.
3. Ensure that your circuit breaker or fuse is working properly, and that the heater is placed on a flat and even surface.
4. Ensure that the temperature is set to be higher than the ambient temperature.

1. If the temperature exceeds the threshold of the thermal cutoff, turn off and unplug the unit. Allow it to cool and plug into the electrical outlet again.
2. If the heater is tipped over, place it on a flat, level and stable surface.
3. In ECO mode, the heater will turn off automatically when the set temperature has been reached. This is normal. If your heater turns off frequently, please raise the set temperature, or switch to Power Heat mode.